First off, choose roads and terrain that are suitable to your ability. If you ski only in the Fall or a few times a year, know that hills with asphalt are less controllable than hills with snow. Just because you ski unrestricted down steep grades on snow, the same should not apply to roads or trails.
Know the road. Be aware of intersections, driveways, and poor pavement. Also be aware that wet pavement has more potential for slips, longer stopping times, and accidents than dry pavement.
Choose roads that are less traveled if possible. Backroads, roads with wide paved shoulders, closed park roads, or bike paths are the preference of most skiers looking for a pleasant roller ski experience.
Safety. Must wear equipment for a roller ski workout is a helmet, light leather ski or work gloves, and a bright colored reflective vest. You may also consider wearing elbow and kneepads, a small compact red flasher, and a headlamp. I include the last two items because as fall progresses we have less daylight hours and most of us train at the end of the day. Being seen on the road is the most important issue regarding safety. You must make sure that you are seen by the drivers on the road. With the use of cell phones and texting, more and more drivers do not have their full attention on the road in front of them.
Maintain your equipment and check it often. Rotate your skis half way through a workout to maintain even wheel wear. You will find that even if you have perfect stance, wheels will wear to one direction from the slope of the pavement almost always being to the right. Check nuts and axle bolts for tightness and soundness. Dry off your equipment after using it in wet conditions. If you use a laminated shaft, this will ensure the life of the ski. Road grit and dirt combined with water are the worst things for your wheel bearings and your boots and bindings. Ski boots were designed for Winter weather, so air out your insoles and dry your equipment every time you ski.
Use road ferrules specifically for roller skiing. While snow baskets do work for a while, most are unable to handle the impact stress of asphalt and do eventually break. Save money in the long run and switch out your ferrules when you start roller skiing. Keep your ferrule tips sharp. I sharpen or touch up my ferrules a couple of times a week. They are very sharp and that is very important in the Fall and early Winter when the asphalt is cold and hard. It will prevent poles from slipping and decrease the potential of injury from “jamming” your poles into the pavement. If you sharpen with a motor wheel, it must be a diamond stone and you must water cool every few seconds. This will keep the road tip from being damaged from the excess heat of grinding. If you do sharpen your tips with a hand stone, then it is even more important to do it each time as once they are dull, it is very difficult to bring a tip back to being sharp by hand.
Skier Etiquette and Behavior:
Lastly, roller skiing is not easy. Some of the drills and practices are very difficult and we are not balancing on a ski board, but instead on the center line of a wheel. If we can’t balance and do these drills in shoes or on dry land, how would we expect to do them on roller skis? And the result of falling on asphalt makes it even more intimidating to most. So, in other words, get some coaching and or take some lessons and make your first experiences on roller skis pleasant and lasting.
Follow these simple guidelines, and you will have a more enjoyable roller ski experience.